Pristatymo terminai
2025-04-11 Numatomas pristatymas užsakius dabar
Prekė užsakoma iš tiekėjo sandėlio. Jei tiekėjas šios prekės pristatyti iki nurodytos datos negalės, informuosime jus el. paštu.
Tiekėjo sandėlis |
Pristatymas į namus
Perdavę prekes kurjeriui, informuosime Jus el. paštu.
Virš 50,00 € (Užsakymams iki 1000 kg) | Nemokamai |
Iki 50,00 € (Užsakymams iki 3 kg) | 3,49 € |
Iki 50,00 € (Užsakymams iki 1000 kg) | 4,99 € |
Pristatymas į paštomatą
Perdavę prekes kurjeriui, informuosime Jus el. paštu. Užsakymai virš 50.00 € pristatomi nemokamai.
2,39 €
Prekės aprašymas
230V Thermostat XH-W3001
Specifikacijos
Prekės kodas
URZ4048
SKU
U-4501361
Barkodai
5903933691749
Tiekėjo prekės aprašymas
Electronic Thermostat Temperature Controller 230V XH-W3001 AC110-230V W3001
The W3001 temperature controller allows you to control various electrical devices such as: heating pumps, water pumps, circulation pumps, etc.
A simple and reliable temperature control system. The controller can operate in "cooling" and "heating" modes, making it a very versatile system.
Specifications:
Input voltage (supply): AC 110-230V
Temperature measurement: -50°C - +110°C
Maximum relay load current: 1500W
Temperature measurement resolution: 0.1°C (up to 99.9°C)
Temperature refresh rate: 0.5s
Sensor used: NTC10K
Temperature measurement probe: waterproof
Probe cable length: 100cm
Length of remaining wires: 8-10cm
Display: 3-digit LED
Display color: red
Dimensions of the housing without mountings: 60 x 45 x 31 mm
Mounting hole spacing: 73 mm
Programming:
Setting the temperature to switch ON the device connected to the controller (start):
Hold down the ^ button for 3 seconds to enter temperature editing mode - the screen should start flashing. During the editing mode, you can set the desired temperature using the ^ and ˇ buttons. After setting the temperature, do not touch the buttons for 3 seconds for the set temperature to be saved.
Setting the temperature to switch OFF the device connected to the controller (stop):
Hold down the ˇ button for 3 seconds to enter temperature editing mode - the screen should start flashing. During the editing mode, you can set the desired temperature using the ^ and ˇ buttons. After setting the temperature, do not touch the buttons for 3 seconds for the set temperature to be saved.
To check the set ON temperature (start) or target temperature (stop), press the ^ or ˇ button once.
ON temperature ^START lower than OFF temperature ˇSTOP - HEATING MODE
ON temperature ^START higher than OFF temperature ˇSTOP - COOLING MODE.
Red wire: power supply (black - neutral).
Yellow wire: receiver, whose operation is to be controlled by the thermostat (black - neutral).
Tiekėjo specifikacijos
Product code
URZ4048
Supplier's product code
LECHPOL24627pl
Product ID
U-4501361
Tiekėjo pateikiama informacija apie prekę gali skirtis nuo realaus produkto. Jei pastebėjote neatitikimų praneškite apie tai el. paštu [email protected].